Thermal barrier
Below 25 mW/mK at room temperature — in a single layer of 1 to 3 mm. Inter-cell spacing in prismatic modules is typically 1 to 2 mm, which rules out most insulation materials before the evaluation even starts.
aero365 · Battery Applications
Between two prismatic cells sits a gap of one to two millimetres. It has to insulate against thermal propagation, absorb cell swelling and hold up when a cell fails. aero365 is engineered for exactly that gap.
01 — Assembled
Five cells, two compression plates, one enclosure. Everything that matters for thermal safety happens in the gaps you cannot see.
02 — Opened
One to two millimetres between cells. Too thin for conventional insulation, yet it has to stop heat, take up swelling and survive fire.
03 — Revealed
Silica aerogel in a wet-laid nonwoven. Below 25 mW/mK thermal conductivity, around 90 % inorganic, 1 to 3 mm thin.
04 — One layer
Thermal barrier, compression pad and fire protection — thermoformable into complex three-dimensional geometries, with minimal dust during processing.
05 — Inside the sheet
Staple fibres suspended in water and deposited on a screen — the same principle as papermaking. That is what produces the fibre homogeneity a dry-laid web cannot reach.
Schematic representation · cell and layer shown in scale
Aerogel insulation paper as a cell-to-cell barrier: below 25 mW/mK in 1–3 mm, around 90 % inorganic, UL94 V0 above 800 °C, compressible with good shape recovery.
Why it works
Below 25 mW/mK at room temperature — in a single layer of 1 to 3 mm. Inter-cell spacing in prismatic modules is typically 1 to 2 mm, which rules out most insulation materials before the evaluation even starts.
Cells swell over their service life. aero365 is compressible with good shape recovery, so it absorbs that movement instead of transferring it into the module structure.
Approximately 90 % inorganic and non-combustible, classified UL94 V0 above 800 °C. The barrier stays a barrier when a neighbouring cell fails.
Technical data
Areal weight, thickness and geometry are adapted to the module, not the other way around. Send us your packaging envelope and temperature target — we will tell you what is achievable.